Siemens SINUMERIK 828D - Page 517

Programming technology functions (cycles)
9.5 Contour milling
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
517
Cartesian starting point
1.
Enter the starting point for the contour.
2.
Enter any additional commands in G co
de format, as required.
3.
Press the "Accept" softkey.
4.
Enter the individual contour elements.
Polar starting point
1.
Press the "Pole" softkey.
2.
Enter the pole position in Cartesian coordinates.
3.
Enter the starting point for the contour in polar coordinates.
4.
Enter any additional commands in G code format, as required.
5.
Press the "Accept" softkey.
6.
Enter the individual contour elements.