Siemens SINUMERIK 828D - Page 535

Programming technology functions (cycles)
9.5 Contour milling
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
535
Note
Execution from external media
If you exe
cute programs from an external drive (e.g. local drive or network drive) then you
require the execution from external storage function (EES).
For additional information, please refer to the following references:
Commissioning Manual SINUMERIK Operate (IM9)
/ SINUMERIK 840D sl
Clamping the spindle
For ShopTurn, the "Clamp spindle" function can be set up by the machine manufacturer.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
See also
Clamping the spindle (Page 247)
Procedure when centering
1.
The part program or ShopTurn program to be processed has been cr
e-
ated and you are in the editor.
2.
Press the "Milling", "Mill contour", "Predrilling" and "Centering" softkeys.
The "Centering" input window opens.