Siemens SINUMERIK 828D - Page 553

Programming technology functions (cycles)
9.5 Contour milling
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
553
Procedure
1.
The part program or ShopTurn program to be processed has been cr
e-
ated and you are in the editor.
2.
Press the "Milling", "Contour milling" and "Spigot resid. mat." softkeys.
The "Spigot Res. Mat." input window opens.
3.
For the ShopTurn program, press the "All parameters" softkey if you
want to enter additional parameters.
Parameters, G code program
Parameters, ShopTurn program
PRG Name of the program to be generated T Tool name
PL
Machining plane D Cutting edge number
Milling direction
• Climbing
• Conventional
F
Feedrate mm/min
mm/tooth
RP Retraction plane mm S / V
Spindle speed or constant cut-
ting rate
rpm
m/min
SC
Safety clearance
mm
F
Feedrate
mm/min
parameters
Description
Unit
Machining The following machining technologies can be selected:
• ∇ (roughing)
Machining
surface
(only for ShopTurn)
• Face C
• Face Y
• Face B
• Peripheral surface C
• Peripheral surface Y
(only for ShopTurn)
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
TR Reference tool Tool, which is used in the "stock removal" machining step. This
is used to determine the residual corners.
D
Cutting edge number
Z0
Reference point in tool axes Z
mm