Siemens SINUMERIK 828D - Page 604

Programming technology functions (cycles)
9.7 Additional cycles and functions in ShopTurn
Turning
604 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Note
You can withdraw the blank several times successively without parting in order to continue
the machining on the same side.
Parameter
Description
Unit
Function
You can select between five different functions:
• Complete transfer
• Gripping
• Withdrawing
• Machining side
Workpiece transfer
• Main spindle in counter-spindle
• Counter-spindle in main spindle
Complete transfer
function
Gripping
Coordinate
system
• Machine coordinate system (MCS)
The park position is specified in the machine coordinate system. Teaching
in the park position and angular offset is only possible in the machine coor-
dinate system.
• Workpiece coordinate system (WCS)
The park position is specified in the workpiece coordinate system.
XP
Park position of tool in X direction (abs)
mm
ZP
Park position of tool in Z direction (abs)
mm
Flush chuck Flush counter-spindle chuck
• Yes
• No
DIR Direction of rotation
•
Spindle rotates clockwise
•
Spindle rotates counter-clockwise
•
Spindle does not rotate
Clamping Clamping both spindles (only if spindles are not turning)
•
Clamping open
•
Clamping closed
S
Spindle speed – (only when the spindle rotates)
rev/min
α1
Angular offset
Degrees
Z1
Transfer position (abs.)
ZR Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
FR
Reduced feedrate
mm/rev