Siemens SINUMERIK 828D - Page 66

Introduction
2.4 User interface
Turning
66 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
4.
Press the "Keyword index" softkey if you only want to display the index
of the operating and programming manual.
Displaying alarm descriptions and machine data
1.
If messages or alarms are pending in the "Alarms", "Messages" or
"Alarm Log" window, position the cursor a
t the appropriate display and
press the <HELP> or the <F12> key.
The associated alarm description is displayed.
2.
If you are in the "Start
-up" operating area in the windows for the display
of the machine, setting and drive data, position the cursor on the d
e-
sired machine data or drive parameter and press the <HELP> or the
<F12> key.
The associate
d data description is displayed.
Displaying and inserting a G code command in the editor
1.
A program is opened in the editor.
Position the cursor on the desired G code command and press the
<HELP> or the <F12> key.
The associated G code description is displayed.
2.
Press the "Display all G functions" softkey.
3.
With the aid of the search function, select, for example, the desired G
code command.
4.
Press the "Transfer to editor" softkey.
The selected G function is taken into the program at the cursor p
osition.
5.
Press the "Exit help" softkey again to close the help.