Siemens SINUMERIK 828D - Page 777

Managing programs
13.17 Setup data
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
777
Data
Zero points
• No
The selection box "Basis zero point" is hidden
• All used in the program (only for ShopTurn program and job list only
with ShopTurn programs)
• All
Zero points for ShopTurn
programs
--
only available for job list
with ShopTurn and G
code programs
• No
The selection box "Basis zero point" is hidden
• All used in the program
• Complete tool list
Zero points for G code
programs
-- only availa
ble for job list
with ShopTurn and G
code programs
• No
The selection box "Basis zero point" is hidden
• All
Basic zero points
• No
• Yes
Directory
The directory is displayed, in which the selected program is located.
File name
Here you have the option of changing the suggested file names.
Note
Magazine assignment
You can only read out the magazine assignments if your system provides support for loading
and unloading tool data to and from the magazine.