Sony MVS-8000X SystemMVS-7000X System - Page 172

USO RESTRITO
172
Basic Procedure for Wipe Settings
Chapter
5
Wipes
You can set pattern replication independently for the main
pattern and sub pattern.
1 In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2 Press [Multi], turning it on.
3 Set the following parameters.
Knob
Parameter
Adjustment
Setting values
1
H Multi
Number of
repetitions of
pattern
horizontally
1 to 63
2
V Multi
Number of
repetitions of
pattern
vertically
1 to 63
3
Shift
Replication
layout
–100.00 to
+100.00
4 To make more adjustments, press [Multi Adjust].
The Multi Adjust menu appears.
5 Make the following settings, as required.
H Invert: When this is on, alternate tiles are inverted
left-to-right.
V Invert: When this is on, alternate tiles are inverted
top-to-bottom.
Non-Mask: When this is on, even if the positioner
function is used to move the pattern position, the
pattern is always present on the screen.
Position: By adjusting the following parameters,
move the pattern position within the divisions
determined in step 3.
Knob
Parameter
Adjustment
Setting values
1
Position H
Horizontal
position of
pattern
–200.00 to
+200.00
a)
2
Position V
Vertical position
of pattern
–200.00 to
+200.00
a)
a) See page 169.
Making a wipe pattern like a Venetian blind
(Pairing)
This slits the pattern into multiple strips in the horizontal
or vertical direction, making it like a venetian blind.
Pairing Off Pairing On
• The parameter Width determines the width of the slits.
• The parameter H Offset determines the spacing in the
horizontal direction.
If a negative value is set, the even-numbered pairs of
strip and slit move to the left, and the odd-numbered
pairs move to the right. The value –100.00 represents the
maximum movement.
If a positive value is set, the even-numbered pairs of strip
and slit move to the right, and the odd-numbered pairs
move to the left. The value +100.00 represents the
maximum movement.
• The parameter V Offset determines the spacing in the
vertical direction.
If a negative value is set, the even-numbered pairs of
strip and slit move upward, and the odd-numbered pairs
move downward. The value –100.00 represents the
maximum movement.
If a positive value is set, the even-numbered pairs of strip
and slit move downward, and the odd-numbered pairs
move upward. The value +100.00 represents the
maximum movement.
1 In the M/E-1 >Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2 In the <Pairing> group, select the slit direction.
H: Create slits in the horizontal direction.
V: Create slits in the vertical direction.
3 Set the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Width
Width of the
slits
1 to 128
(integer)
2
H Offset
Spacing in the
horizontal
direction
–100.00 to
+100.00
3
V Offset
Spacing in the
vertical direction
–100.00 to
+100.00
Applying modulation to the wipe pattern
(Modulation)
The pattern signal can be modulated, creating waves in the
horizontal, vertical, or radial direction along the edges.