Sony MVS-8000X SystemMVS-7000X System - Page 298

USO RESTRITO
298
Applying Special Effects (Edge Effects)
Knob
Parameter
Adjustment
Setting values
1
Axis Loc H
Move the
shadow
center axis
horizontally
–8.00 to +8.00 (SD)
–24.00 to +24.00
(HD)
2
Axis Loc V
Move the
shadow
center axis
vertically
–6.00 to +6.00 (SD)
–18.00 to +18.00
(HD)
Knob
Parameter
Adjustment
Setting values
1
Axis Loc H
Move the
shadow
center axis
horizontally
–8.00 to +8.00 (SD)
–32.00 to +32.00
(HD)
2
Axis Loc V
Move the
shadow
center axis
vertically
–4.50 to +4.50 (SD)
–18.00 to +18.00
(HD)
Chapter
11
DME
Operations
2 Adjust the following parameters.
The valid ranges of the parameter values depend on the
combination of signal format (SD/HD) and aspect
ratio (4:3/16:9) selected in the system, as follows.
4:3 mode
16:9 mode
Skewing the flex shadow
1 In the Flex Shadow menu, press [Skew], turning it on.
2 Adjust the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Skew H
Skew
horizontally
–100.00 to +100.00
2
Skew V
Skew
vertically
–100.00 to +100.00
Adding perspective to the flex shadow
1 In the Flex Shadow menu, press [Perspective], turning
it on.
2 Adjust the following parameters.
Knob
Parameter
Adjustment
Setting values
1
Perspective
H
Add
horizontal
perspective
–100.00 to +100.00
2
Perspective
V
Add vertical
perspective
–100.00 to +100.00
When the default Axis
Loc setting is used
Axis Loc V
Axis Loc H
Shadow skewed
with Axis Loc set at
the lower left corner
of the picture
Shadow size and
perspective adjusted
with default Axis Loc
setting
Perspective
H = –100
Perspective
H = +100
Shadow skewed with
Axis Loc set at the
midpoint on the left
edge of the picture
Perspective
V = –100
Inverting the flex shadow
Perspective
V = +100
Picture
Flex shadow
Axis Loc position
The flex shadow central axis appears when the [Flex
Shadow Axis] function is enabled in the Graphic menu.
For details, see “Graphics Display Operation” (page
287).
In the <Invert> group of the Flex Shadow menu, select the
direction to invert the shadow.
H: Invert the shadow in the horizontal direction. The
inversion is applied around the axis of the knob 2
parameter Axis Loc V set with [Axis Loc].
V: Invert the shadow in the vertical direction. The
inversion is applied around the axis of the knob 1
parameter Axis Loc H set with [Axis Loc].