Creating and Editing Keyframes 451
Chapter
13
Keyframe
Effects
The different procedures for these cases are now
described.
To modify from the edit point to a particular
keyframe
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at the first keyframe of the range to be
modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button, turning it on.
The display in the numeric keypad control block
shows the current keyframe number, followed by
“TO.”
5
Enter the number of the last keyframe to be modified
from the numeric keypad control block and press the
[ENTER] button to confirm.
6
Press the [MOD] button. Alternatively, hold down the
[SHIFT] button and press the [MOD] button.
For the difference in the result, see “Differences in the
changes when a number of keyframes are modified”
(page 451).
To modify all keyframes in the effect
1
Press the [EDIT ENBL] button, turning it on.
2
Carry out the necessary modifications on any
keyframe.
3
Press the [ALL] button, turning it on.
4
Press the [MOD] button. Alternatively, hold down the
[SHIFT] button and press the [MOD] button.
For the difference in the result, see “Differences in the
changes when a number of keyframes are modified”
(page 451).
To modify the keyframes in a specified range
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect at any keyframe within the range to be
modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button, turning it on.
The display in the numeric keypad control block
shows the current keyframe number, followed by
“TO.”
5
Using the numeric keypad in the numeric keypad
control block, carry out the following operations.
•
To set the first keyframe in the range to be modified,
press the [CLR] button, then enter the keyframe
number, and press the [ENTER] button to confirm.
•
To set the last keyframe in the range to be modified,
enter the keyframe number from the numeric
keypad, and press the [ENTER] button to confirm.
6
Press the [MOD] button. Alternatively, hold down the
[SHIFT] button and press the [MOD] button.
For the difference in the result, see “Differences in the
changes when a number of keyframes are modified”
(page 451).
Differences in the changes when a number
of keyframes are modified
When you select a number of keyframes to modify, and
press the [MOD] button alone or in combination with the
[SHIFT] button, the result of the operation differs as
shown below.
Modifying the keyframes by pressing the [MOD]
button alone
The modified parameter values are taken as absolute
values, and applied to all of the selected keyframes.
: Background A
: Background B
Keyframe 1 Keyframe 2 Keyframe 3 Effect
execution
Modify keyframe 2.
(Changing the position of
background B in the horizontal
direction)
Select keyframes 1 to 3 and modify
simultaneously.
Keyframe 1 Keyframe 2 Keyframe 3 Effect
execution
Result:
The horizontal position of background B in keyframes 1
and 3 is now the same as that in keyframe 2.
In all keyframes, the vertical position remains unchanged
as the parameter is not changed.
Modifying the keyframes by holding down the
[SHIFT] button and pressing the [MOD] button
The modified parameter values are taken as relative
values, which modify all of the selected keyframes.
To Next Page
Loading...
