Auxiliary Bus Control Block Settings (Aux Assign Menu) 587
Source selection
button selection
Source selection
in S-Bus space
Chapter
19
Control
Panel
Setup
(Panel)
The Aux Assign menu appears.
2 Press [RTR Mode Setting].
The RTR Mode Setting menu appears. The left of the
status area shows the destination number assignment
status and source table, and the right side lists the
destinations that can be assigned.
Assigning a destination to a destination
selection button
In the Panel >Aux Assign >RTR Mode Setting menu, use
the following procedure.
1
Using any of the following methods, select a
destination selection button and the destination to be
assigned to the button.
•
Press directly on the list in the status area.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knobs.
Destination
selection button
selection
Destination
selection in S-Bus
space
For a button whose operation you want to disable,
press [Inhibit].
Notes
When a destination selection button having a number
in the range 65 to 128 is selected, source table
selection automatically becomes invalid, and therefore
the Inhibit function also becomes invalid.
2
Press [Dest Set] to confirm the selection.
3
If in step 1 you selected a value in the range 1 to 64, turn
the knob to select the source table.
4
Press [Source Table Set] to confirm the selection.
5
Repeat steps 1 to 4 as required.
To set the shift operation of the destination
selection buttons
To set the operation mode of the rightmost button in the
destination selection button row, select one of the
following in the <Dest Shift Mode> group of the Panel
>Aux Assign >RTR Mode Setting menu.
Hold: Acts as a shift button, and the shifted destination
selection buttons are enabled while the button is held
down.
Lock: Acts as a shift button, and pressing the button
toggles between the shifted and unshifted states of the
destination selection buttons.
Off: Acts as a destination selection button, that is, button
number 16 on a 16-button system, button number 24
on a 24-button system, and button number 32 on a 32-
button system.
Setting the source table
1
In the Panel >Aux Assign >RTR Mode Setting menu,
press [Source Table Assign].
The Source Table Assign menu appears.
2
In the <Source Table Select> group, select the source
table you want to manipulate.
3
Press [Table Assign].
The Table Assign menu appears.
The left of the status area lists the button numbers and
set sources, and the right side lists the source that can
be assigned.
4
Using any of the following methods, select a source
selection button and the source you want to assign.
•
Press directly on the list in the status area.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knobs.
For a button whose operation you want to disable,
press [Inhibit].
5
Press [Source Set] to confirm the selection.
To set the shift operation of the source selection
buttons
To set the operation mode of the rightmost button in the
source selection button row with different destinations
assigned to the 1st and 2nd rows, select the source table in
the Source Table Assign menu, then in the <Xpt Shift
Mode> group select one of the following.
Hold: Acts as a shift button, and the shifted source
selection buttons are enabled while the button is held
down.
To Next Page
Loading...
