Signal Input Settings (Input Menu) 615
Up-converted image (16:9)
Chapter
20
Switcher
Setup
(Switcher)
•
Press directly on the list in the status area.
•
Press the arrow keys to scroll the reverse video
cursor.
•
Turn the knob.
a) The setting values vary with the button pressed in step 2.
Making detailed settings for up-conversion
1
In the Switcher >Input >FC Adjust menu, select the
input to which the setting applies.
2
In the <Conversion> group, select one of the
following.
Frame: Conversion in frame units
Field: Conversion in field units
Adaptive: Automatically switching between the
above two modes
When Adaptive is selected, adjust the following
parameter.
Motion detection
sensitivity
a)
1: Still priority mode, 2: Standard mode, 3: Motion priority mode
3
In the <Aspect> group, select one of the following.
Edge Crop: Add black bars on the left and right sides
of a 4:3 aspect ratio image to convert it to a 16:9
image.
Letter Box: Crop the top and bottom of a 4:3 aspect
ratio image to convert it to a 16:9 image.
Squeeze: Stretch a 4:3 image horizontally to covert it
to a 16:9 image.
For details of the image transformations, see the
following figure.
Setting the image position in edge crop up-
conversion mode
1
In the <Edge Crop Position> group of the Switcher
>Input >FC Adjust menu, press [Position], turning it
on.
2
Adjust the following parameter.
a)
For down-conversion, the value is from –30 to +30 inclusive.
To return the edge crop image to the center
In the <Edge Crop Position> group, press [Center].
Setting the image position in letter box up-
conversion mode
1
In the <Letter Box Position> group of the Switcher
>Input >FC Adjust menu, press [Position], turning it
on.
2
Adjust the following parameter.
To Next Page
Loading...
