Sony MVS-8000X SystemMVS-7000X System - Page 688

USO RESTRITO
688
Error Messages
Appendix
(Volume
2)
Icon
Message
Description
Prepare failed, all one Clip recall failed
(–17).
2564: Frame Memory >External Device >Backup to DDR/VTR
When [Backup Start] was pressed, All One Clip recall failed (internal
processing error).
ERROR (–19). Bad register number.
2564: Frame Memory >External Device >Backup to DDR/VTR
When [Backup Start] was pressed, the Register Number was an invalid
value (internal processing error).
Prepare failed, because there is clip
playing (–22).
2564: Frame Memory >External Device >Backup to DDR/VTR
When [Backup Start] was pressed, processing failed because clip playback
was in progress.
Change Password
The password has been successfully
changed.
7317.1: Engineering Setup >System >Maintenance >Setup Operation Lock
The password was successfully changed.
Failed.
The password was not changed.
7317.1: Engineering Setup >System >Maintenance >Setup Operation Lock
The password could not be changed.
Create Key Frame
[Create Key Frame] cannot be
executed.
FMx is not assigned to a user region.
2515: Frame Memory >Still >Create Key Frame
When [Create Key Frame] was pressed, the frame memory output (FMx)
was not assigned to a User region.
Assign the output in menu 7331.4 (Engineering Setup >Switcher >Config
>User1–8 Config), and try again.
[Create Key Frame] cannot be
executed.
Key Frame Register is locked. (UserX)
2515: Frame Memory >Still >Create Key Frame
When [Create Key Frame] was pressed, the register (UserX region) was
locked. Unlock the register.
[Create Key Frame] cannot be
executed.
Key Frame Register is busy. (UserX)
2515: Frame Memory >Still >Create Key Frame
When [Create Key Frame] was pressed, files were being loaded into the
register (UserX region). Try again after file loading has finished.
[Create Key Frame] cannot be
executed.
Key Frame Register is being edited.
(UserX)
2515: Frame Memory >Still >Create Key Frame
When [Create Key Frame] was pressed, keyframe creation or editing was in
progress using register (UserX region). Try again after the keyframe
operation has finished.
[Create Key Frame] cannot be
executed.
There is no free Key Frame. (UserX)
2515: Frame Memory >Still >Create Key Frame
When [Create Key Frame] was pressed, an insufficient number of usable
keyframes were in UserX region.
[Create Key Frame] cannot be
executed.
Key Frame Register is not active.
(UserX)
2515: Frame Memory >Still >Create Key Frame
When [Create Key Frame] was pressed, the region selection button for the
register in the numeric keypad control block was not selected. Select the
region selection button [UserX] in the numeric keypad control block, and try
again.
Deactivate License
The license will be deactivated after
rebooting your system.
7316.7: Engineering Setup >System >Install/Unit Config >License >License
Management
The Deactivate License procedure was completed successfully.
Disk Format
Success!!
7317: Engineering Setup >System >Maintenance
Formatting of the removable disk was completed successfully.
Failure.
Make sure of the memory card.
7317: Engineering Setup >System >Maintenance
Formatting of the removable disk failed. Check that the memory card is
correctly inserted.
Error
This operation is cancelled, because
the register is locked.
Please change the register status to
be unlocked first.
6211.1: Effect >Master Timeline >Store >Edit
6311.1: Snapshot >Master Snapshot >Store >Edit
6411.1: Shotbox >Register >Store/Recall >Edit
An attempt was made to assign a locked register. Unlock the register before
carrying out the assignment.