Xilinx Zynq-7000

Zynq-7000 AP SoC and 7 Series FPGAs MIS v4.1 275
UG586 November 30, 2016
www.xilinx.com
Chapter 2: QDR II+ Memory Interface Solution
IMPORTANT: Memory Interface Solutions v4.1 only supports the Vivado
®
Design Suite. The ISE
®
Design Suite is not supported in this version.
Using MIG in the Vivado Design Suite
This section provides the steps to generate the Memory Interface Generator (MIG) IP core
using the Vivado Design Suite and run implementation.
1. Start the Vivado Design Suite (see Figure 2-1).
2. To create a new project, click the Create New Project option shown in Figure 2-1 to
open the page as shown in Figure 2-2.
X-Ref Target - Figure 2-1
Figure 2-1: Vivado Design Suite
Send Feedback