Electrical component and wire harness routing
5-6
1. Cam position sensor (PORT EX)
2. Knock sensor
3. Ignition coil
4. Fuel pressure sensor (direct injection
pump)
5. Direct injection pump
6. Water pressure sensor
7. Cam position sensor lead
8. Blowby hose
9. Knock sensor coupler
10. Wire harness
11. Fuel injector sub-wire harness
12. SCU positive lead
13. SCU coupler (3P)
14. SCU coupler (4P)
15. SCU communication lead coupler (4P)
16. SCU communication lead coupler (6P)
17. PTT lead
a. Wire harness guide edge
A. Position the plastic tie within 20 mm
(0.79 in) of the wire harness guide edge.
B. Route the knock sensor lead so that it
does not protrude above the blowby
hose.
C. Fit the protrusion on the wire harness
holder into the hole in the guide plate.
D. Cut off the excess end of the plastic tie
at a point below the wire harness guide.
E. Install the holder in the direction shown
in the illustration.
F. For single outboard motor.
G. For port outboard motor and starboard
outboard motor.
H. For center outboard motor.
To Next Page
Loading...
