EasyConnect RCT 1.0
Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
G-32
Figure G.37 Please Wait Message
Note: If all your HFA instruments cannot respond fast enough you will receive a message such as
“No instruments are responding. Please try again later” or “Could not retrieve instrument
configuration data. Please try again later.”
If at least one HFA instrument responds, you will not
receive a message. If you receive one of these messages, select the Back button until you see the
EasyConnect
RCT Welcome screen, and then run the RCT again.
2 A list of all networked HFA II-
i
instruments will be displayed (Figure G.38). All instruments are
selected by default. Select the instruments you want
to display configurations for and then
select
NEXT to continue. CTRL-CLICK to select or deselect multiple instruments.
Figure G.38 Select Networked HFA Instruments to Display Configurations
Note: The name of the HFA II-
i
instrument can be created on the instrument in the HFA Network
Setup Screen. Creating a name for an instrument can allow you to know the location of the
instrument. If you do not create a name, then the Name field in the instrument list will be empty
(see “Enable the RCT and Name HFA II-i Instruments,” on page G-3).
To Next Page
Loading...
