A
B
C
D
E
F
G
H
L
M
N
P
section
F 2
14 1098/1098S - M.Y. 2007 - edition 00
Controls - Devices
Locate the hose (6) on the slave cylinder (23), ensuring that the hose end fitting is correctly positioned relative to the slave
cylinder.
Warning
If the clutch hose end fitting is incorrectly positioned, the hose may interfere with moving parts and lead to clutch faults.
Locate the two sealing washers (17) and tighten the banjo bolt (5) to the specified torque (Sect. C 3).
Refit the bleed valve (3) and the dust cap (4).
Refer to the diagram on the following page for correct positioning of the hose retaining clips.
Operation Section reference
Fill the clutch system D 4
Refit the left side fairing E 2
6
5
3
4
17
23
To Next Page