A
B
C
D
E
F
G
H
L
M
N
P
section
D 4
451098/1098S - M.Y. 2007 - edition 00
Use and maintenance
Adjusting the rear ride height
The original frame geometry represents the result of extensive testing by DUCATI engineers in the widest possible range of riding
conditions. Modifying the frame geometry is a very critical operation, and can be dangerous if carried out by untrained persons.
Given that this motorcycle is often used in competition, DUCATI has decided to equip this motorcycle with the means to alter
the geometry of the rear suspension and the steering head to suit the needs of different circuits and track conditions.
Changing the rear height
To determine the existing rear ride height, proceed as follows:
Park the motorcycle on level surface and support it an upright position.
Measure the height (H). Make a note of the measurement so as to be able to restore the original setting later on.
To alter the height (H), adjust the tie-rod (2) as follows:
Loosen lock nuts (3) on ball joint end fittings (1); note that the lower lock nut has a left-hand thread.
Using a wrench on the flats in the centre, turn the tie-rod (2) to obtain the desired height.
Warning
The length of the tie-rod (2) between the centres of the two ball joints (1) must not exceed 166.7 mm.
Tighten the lock nuts (3) to the specified torque (Sect. C 3).
H
1
3
2
3
1
To Next Page
Loading...
