A
B
C
D
E
F
G
H
L
M
N
P
section
D 4
30 1098/1098S - M.Y. 2007 - edition 00
Use and maintenance
Filling the clutch circuit
Warning
Clutch fluid will damage painted surfaces if spilled on them. It is also very harmful if it comes into contact with the skin or with
the eyes; in the event of accidental contact, wash the affected area with abundant running water.
Fill the reservoir with the recommended fluid (Sect. C 2) from a previously unopened container.
Important
During the following operation, the fluid level must remain topped up at all times. The end of the transparent plastic tubing must
remain immersed in the discharged fluid at all times.
Operate the clutch lever and keep it pulled to fill the circuit and expel any air.
Connect the bleed tool to the bleed valve (2).
Notes
Follow the manufacturer's instructions when using a commercial clutch bleeding tool.
Pump with the bleeding tool and loosen off the bleed valve (2). Check that the reservoir level does not fall below the MIN mark.
Repeat the bleeding operation until the fluid flowing from the tube is completely free of air bubbles.
If you do not have a bleeding tool available, connect a length of transparent plastic tubing to the bleed valve (2) as outlined in the
draining procedure.
MAX
MIN
2
To Next Page
Loading...
