A
B
C
D
E
F
G
H
L
M
N
P
section
D 4
291098/1098S - M.Y. 2007 - edition 00
Use and maintenance
To help drain the circuit fully, unscrew the three retaining screws (3) and remove the slave cylinder cap from the engine.
Remove the clutch slave cylinder (4) taking care not to damage the internal O-ring (5).
Push in the internal piston to force out all the fluid from inside the cap.
Refit the slave cylinder cap and tighten retaining screws (3) to the specified torque (Sect. C 3).
Tighten the bleed valve to the specified torque (Sect. C 3).
3
4
3
5
To Next Page
Loading...
