EasyManua.ls Logo

Ducati 1098 2007 - General Maintenance Indications

Ducati 1098 2007
714 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A
B
C
D
E
F
G
H
L
M
N
P
section
A 3
10 1098/1098S - M.Y. 2007 - edition 00
Generalità
General maintenance indications
Useful tips
Ducati recommends that you follow the instructions below in order to prevent problems and obtain the best end result:
- When diagnosing faults, primary consideration should always be given to what the customer reports about motorcycle
operation since this information can highlight anomalies; your questions to the customer concerning symptoms of the fault
should be aimed at clarifying the problem;
- diagnose the problem systematically and accurately before proceeding further. This manual provides the theoretical background
for troubleshooting; this basis must be combined with personal experience and attendance at periodic training courses held by
Ducati;
- repair work should be planned carefully in advance to prevent any unnecessary downtime, for example obtaining the required
spare parts or preparing the necessary tools, etc.;
- limit the number of operations needed to access the part to be repaired. Note that the disassembly procedures in this manual
describe the most efficient way to reach the part to be repaired.
General advice on repair work
- Always use top quality tools. When lifting the motorcycle, only use devices that comply fully with the relevant European
directives.
- When working on the motorcycle, always keep the tools within reach, ideally in the order required, and never put them on the
motorcycle or in hard-to-reach or inaccessible places.
- The workplace must be kept clean and tidy at all times.
- Always replace gaskets, seals and split pins with new parts.
- When loosening or tightening nuts and bolts, always start with the largest or start from the centre; tighten nuts and bolts to the
specified torque working in a crosswise sequence.
- Always mark any parts and positions which might easily be confused at the time of reassembly.
- Use exclusively Ducati original replacement parts and the recommended brands of lubricants.
- Use special service tools where specified.
- Ducati Technical Bulletins often contain updated versions of the service procedures described in this manual. Check the latest
Bulletins for details.
WWW.PlanDeGraissage.ORG

Table of Contents

Related product manuals