A
B
C
D
E
F
G
H
L
M
N
P
section
G 7
56 1098/1098S - M.Y. 2007 - edition 00
Wheels - Suspensions - Brakes
Removal of the rear suspension rocker arm
Disconnect the top of the rear shock absorber from the rocker arm as described in “Removal of the rear shock absorber” in this
section.
Separate the tie-rod (14) and the rocker arm (8) by unscrewing the bolt (4) and recover the collars (11) from either side of the ball
joint (13).
Before removing the rocker arm (8) from the frame, check the play of its internal needle roller bearings (7).
Grasp the rear end of the rocker arm and try to move it in all four directions.
If excessive play is encountered, the bearings need to be renewed.
To remove the rocker arm (8) from the frame, unscrew the nut (3) and withdraw the washer (2).
Slide out the bolt (1) and remove the rocker arm assembly (8) from the frame.
14
4
13
8
11
8
7
7
8
2
3
8
1
To Next Page
Loading...
