A
B
C
D
E
F
G
H
L
M
N
P
section
N 3.3
331098/1098S - M.Y. 2007 - edition 00
Engine
Removal of the water pump
Notes
For clarity, the figures show the engine removed from the frame.
Undo and remove the five screws (13) securing the water pump cover (12) to the left-hand side crankcase cover (16).
Remove the water pump cover (12).
Clean the pump housing of any scale. Rotate the impeller shaft (10) to check the bearings for wear. If there is excessive play,
renew the bearings as described below.
Remove the circlip (3) and washer (4) from the impeller shaft.
Withdraw the impeller (10) with the mechanical seal (9) from the outside.
Operation Section reference
Remove the side fairings E 2
Drain the cooling system D 4
Remove the cooling circuit hoses from the
water pump cover.
N3.2
Remove the left-hand side crankcase
cover
N8
13
13
13
12
16
10
3
To Next Page
Loading...
