A
B
C
D
E
F
G
H
L
M
N
P
section
G 7
60 1098/1098S - M.Y. 2007 - edition 00
Wheels - Suspensions - Brakes
Grease the thread and underside of the head of the lower mounting bolt (17), and tighten it to the specified torque (Sect. C 3).
Install the collars (11) on both the ball joints end fittings.
Install the lower end of the tie-rod (14) on the swingarm.
Grease the thread, underside and sliding surface of the lower pivot bolt (18) and insert it in the swingarm from the right-hand
side. Tighten the bolt (18) to the specified torque (Sect. C 3).
Grease the thread and the underside of the head of the upper tie-rod bolt (4) and insert it in the rocker arm.
Fit the upper end of the tie-rod to the rocker arm and tighten the bolt (4) to its specified torque (Sect. C 3).
Operation Section reference
Refit the rear wheel G 4
Refit the seat cowling E 3
10
B
17
18
14
B
11
11
14
4
8
B
To Next Page
Loading...
