A
B
C
D
E
F
G
H
L
M
N
P
section
N 9.2
2171098/1098S - M.Y. 2007 - edition 00
Engine
Ensure that the crankshaft can be turned with a certain amount of interference with the main bearings (the crankshaft should
have a pre-load of 0.20 to 0.30 mm); check also that all the parts you have fitted are free to rotate or move correctly.
Install the gauze filter cover with its gasket as described in Sect. D 4.
Fit the filter cartridge (Sect. D 4).
Install the oil seal (8) on the gearbox output shaft.
Fit on the output shaft the socket of tool part no. 88713.2060. Lubricate the new oil seal (8) and guide it into its seat.
Using the tool's drift, drive the oil seal fully home so it seats against the crankcase bearing.
Operation Section reference
Refit the clutch assembly N 6.1
Refit the right-hand crankcase cover N 6.2
Refit the engine starter system P 3
Refit the left-hand crankcase cover and
alternator assembly
N8
Refit the cylinder barrel/piston assemblies N 5
Refit the cylinder head assemblies and the
timing parts
N4.2
Refit the cooling system N 3
Refit the lubrication system N 2.1
Install the engine in the frame N 1
8
88713.2060
A
To Next Page
Loading...
