A
B
C
D
E
F
G
H
L
M
N
P
section
N 9.3
224 1098/1098S - M.Y. 2007 - edition 00
Engine
Unscrew all the plugs (4) and (7) from the crankshaft, heating the crankshaft, if necessary, to release the threadlocker applied at
the time of assembly.
Clean all the oilways using suitable diameter metal brushes and then blow with compressed air to remove any residues that have
accumulated and are restricting the oil flow.
Apply THREE BOND 1375B liquid gasket to the plug threads (4) and (7) and reinstall them.
Tighten all the plugs to the specified torque (Sect. C 3).
4
4
7
To Next Page
Loading...
