A
B
C
D
E
F
G
H
L
M
N
P
section
D 4
12 1098/1098S - M.Y. 2007 - edition 00
Use and maintenance
Remove the filler plug (2) and fill with oil of the recommended type (Sect. C 2) up to the MAX line in the sight glass.
Refit the filler plug (2). Run the engine at idle speed for a few minutes.
Check for oil leaks. Check that the oil pressure light on the instrument panel switches off a few seconds after the engine starts.
If not, switch off the engine and trace the fault.
After a few minutes, check the oil level again and top up to the MAX level line, if necessary.
Refit any parts you have removed.
MAX
MIN
2
To Next Page
Loading...
