A
B
C
D
E
F
G
H
L
M
N
P
section
P 2
42 1098/1098S - M.Y. 2007 - edition 00
Electric system
Warning
Do not peel or perforate the sealed areas.
Place the electrolyte container (2) upside down. Align the six sealed elements with the six filler holes on the battery. Push the
container (2) downwards with sufficient force to break the seals and allow the liquid to flow out.
Notes
Do not tilt the electrolyte container as this could interrupt the flow temporarily or even permanently.
Make certain that air bubbles emerge from all six filler holes. Leave the container in this position for at least twenty minutes.
If no bubbles emerge from one of the holes, tap gently on the bottom of the respective container.
Important
Never move the container away from the battery. Do not cut or puncture the liquid container.
Make sure that all the electrolyte has flowed out. Carefully extract the container (2) from the battery.
Place the cap strip (3) previously removed from the electrolyte container (2) on the battery, making sure that the strip closes all
the electrolyte filler holes correctly.
For 3 -12 Ah batteries, leave to stand for at least 30 mins.
For batteries of over 12 Ah, leave to stand for at least 1 hour.
2
2
3
To Next Page
Loading...
