A
B
C
D
E
F
G
H
L
M
N
P
section
D 4
211098/1098S - M.Y. 2007 - edition 00
Use and maintenance
Attach a length of transparent plastic tubing to the bleed valve (5) and insert the other end of the tubing in a container placed on
the floor.
Warning
During the filling operation, always keep the fluid level above the MIN mark to prevent the formation of air bubbles in the circuit.
Allow the fluid to flow from the bleed valve (5) until it changes colour.
Tighten the bleed valve (5) and restore the correct fluid level in the reservoir.
Replace the cap (4), screwing it firmly on to the reservoir (B).
5
MAX
MIN
4
B
To Next Page
Loading...
