F
IGURES
– 39 –
Figure 68: Enabling QinQ Tunneling 176
Figure 69: Adding an Interface to a QinQ Tunnel 177
Figure 70: Configuring Protocol VLANs 179
Figure 71: Displaying Protocol VLANs 179
Figure 72: Assigning Interfaces to Protocol VLANs 181
Figure 73: Showing the Interface to Protocol Group Mapping 181
Figure 74: Configuring IP Subnet VLANs 183
Figure 75: Showing IP Subnet VLANs 183
Figure 76: Configuring MAC-Based VLANs 185
Figure 77: Showing MAC-Based VLANs 185
Figure 78: Configuring MAC Address Learning 188
Figure 79: Configuring Static MAC Addresses 190
Figure 80: Displaying Static MAC Addresses 190
Figure 81: Setting the Address Aging Time 191
Figure 82: Displaying the Dynamic MAC Address Table 192
Figure 83: Clearing Entries in the Dynamic MAC Address Table 193
Figure 84: STP Root Ports and Designated Ports 196
Figure 85: MSTP Region, Internal Spanning Tree, Multiple Spanning Tree 197
Figure 86: Common Internal Spanning Tree, Common Spanning Tree, Internal
Spanning Tree 197
Figure 87: Configuring Port Loopback Detection 199
Figure 88: Configuring Global Settings for STA (STP) 203
Figure 89: Configuring Global Settings for STA (RSTP) 203
Figure 90: Configuring Global Settings for STA (MSTP) 204
Figure 91: Displaying Global Settings for STA 205
Figure 92: Configuring Interface Settings for STA 209
Figure 93: STA Port Roles 211
Figure 94: Displaying Interface Settings for STA 211
Figure 95: Creating an MST Instance 213
Figure 96: Displaying MST Instances 213
Figure 97: Modifying the Priority for an MST Instance 214
Figure 98: Displaying Global Settings for an MST Instance 214
Figure 99: Adding a VLAN to an MST Instance 215
Figure 100: Displaying Members of an MST Instance 215
Figure 101: Configuring MSTP Interface Settings 217
Figure 102: Displaying MSTP Interface Settings 217
Figure 103: Configuring Rate Limits 220
To Next Page
Loading...
Need help?
General
