C
HAPTER
19
| IP Services
Dynamic Host Configuration Protocol
– 472 –
CLI REFERENCES
â—† "service dhcp" on page 984
PARAMETERS
These parameters are displayed in the web interface:
◆ DHCP Server – Enables or disables the DHCP server on this switch.
(Default: Disabled)
WEB INTERFACE
To enable the DHCP server:
1. Click IP Service, DHCP, Server.
2. Select Configure Global from the Step list.
3. Mark the Enabled box.
4. Click Apply.
Figure 296: Enabling the DHCP Server
SETTING EXCLUDED ADDRESSES
Use the IP Service > DHCP > Server (Configure Excluded Addresses – Add)
page to specify the IP addresses that should not be assigned to clients.
CLI REFERENCES
â—† "ip dhcp excluded-address" on page 983
PARAMETERS
These parameters are displayed in the web interface:
◆ Start IP Address – Specifies a single IP address or the first address in
a range that the DHCP server should not assign to DHCP clients.
◆ End IP Address – The last address in a range that the DHCP server
should not assign to DHCP clients.
N
OTE
:
Be sure you exclude the address for this switch and other key
network devices.
To Next Page
Loading...
Need help?
General
