Fuji Xerox DocuPrint CM305 df - Enabling the Panel Lock

4 - 86
Chapter 4 Disassembly / Assembly and Adjustments
[Replacement]
1) After the inserting the left shaft of
the ROLL ASSY REGI into the hole
of the FEEDER ASSY MG AIO,
insert the right shaft of the ROLL
ASSY REGI into the hole. Attach
the ROLL ASSY REGI together with
the ACTUATOR REGI OUT and the
ACTUATOR REGI ROLL M.
NOTE
When carrying out the work
this procedure, move the
ACTUATOR REGI OUT to
right until it stops.
2) Attach the BEARING R to the
ROLL ASSY REGI.
NOTE
When carrying out the work
this procedure, it is easier to
push the ROLL REGI
METAL (PL3.2.10) to
frontward.
3) Secure the BEARING R to the
ROLL ASSY REGI with the E-ring
by using the pliers.