Chapter 3 ’Web User Graphical Interface’ — Operating Instructions (Tutorial)
Electra VS
-
Version 05.10 163
User Manual - Rev. A
4.
Set the switching trigger
SDI signal loss
is an optional switching trigger. It is by default enabled.
It may be disabled in the
Jobs
list tab modifying the
Job switching
on SDI sync loss
parameter or in the
SDI input
module modifying
the
Job switching trigger
parameter.
Figure 3-118. Switching trigger selection in the Live SD-HD Encoder Jobs list tab
Figure 3-119. Switching trigger selection, SDI input module
Job not running is also a switching trigger. It can not be disabled
To Next Page
Loading...