Chapter 3 ’Web User Graphical Interface’ — GUI Description
Electra VS
-
Version 05.10 215
User Manual - Rev. A
If simulation mode is
From empty configuration,
the following
parameters must be set:
Blade center C7000 (10RU):
C7000 blade center is added to
the configuration.
The Power Supply must be selected. Choice between
AC 200-240V single phase
,
AC 208V triple phase
,
AC 380V triple
phase
and
DC 48V
.
Blade center C3000 (6RU):
C3000 blade center is added to
the configuration.
The Power Supply must be selected. Choice between
AC 100-240V single phase
and
DC 48V
.
Server 1RU:
1RU Server is added to the configuration.
- If necessary, indicate the SDI board(s) and its model(s) in the
server.
- Indicate the server type. Choice between:
Dual processor
,
Mono processor
.
Number of nodes
: number of
nodes
in the configuration.
- diskless
: node(s) without disk
- with disk
: node(s) with disk
If simulation mode is
From empty configuration
or
From
current configuration
, the following parameters must be set:
Redundancy module number
: number of
nodes
used for
redundancy purposes.
Check IP configuration.
Check this parameter if you want
simulation to check the network resource (addresses &
bandwidth) required by all the jobs.
9.
Click
OK
to launch the Simulation mode.
The
Simulation
view is displayed with a blue background to indicate
that the GUI no longer represents the actual state of Electra VS, but is
dedicated to the simulation.
To Next Page
Loading...