Chapter 4 ’Servicing’ — Software Only Delivery
Electra VS
-
Version 05.10 441
User Manual - Rev. A
The IP address of the new node in the management network will
be processed according to the ip address of the first node + node
id.
For example:
nodeId 1 - 198.18.70.30
nodeId 4 - 198.18.70.33
You can change the node id, the ip address will be change at the
same time.
If it is not the case:
- retry several times, the detection may take several
minutes.
- check the interface configuration and the switch
connection.
c.
Click
Next
.
5.
The node shall be automatically added in your system.
6.
Configure the processing capacity of your node. Refer to
Chapter 7
’Tools’
, section
’NodeBench’
on page 466.
7.
Check the status of the node
a.
Select the
Hardware
tab.
b.
Go to the
Nodes
category.
c.
Check that the status of the node is
OK
.
8.
Finalize the network configuration of your node.
To Next Page
Loading...