Keithley DMM7510 Reference Manual

Section
3: Functions and features Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
3-2 DMM7510-901-01 Rev. B / May 2015
When you set access to full, the instrument accepts commands from any interface with no passwords
required. You can change interfaces as needed.
When you set access to exclusive, you must log out of one remote interface and log into another one
to change interfaces. To use another interface, log out of the present interface before logging into the
new interface. You do not need a password with this access.
Protected access is similar to exclusive access, except that you must enter a password when logging
in.
When you set access to locked out, a password is required to change interfaces, including the front-
panel interface.
Changing the instrument access mode
To change the access mode from the front panel:
1. Press the MENU key.
2. Under System, select Settings. The SYSTEM SETTINGS menu opens.
3. Press the button next to Access Mode.
4. Select the level of password access control you want to enable.
Using SCPI commands
Send the command that is appropriate for the level of access you want to enable:
SYSTem:ACCess FULL
SYSTem:ACCess EXCLusive
SYSTem:ACCess PROTected
SYSTem:ACCess LOCKout
Using TSP commands
Send the command that is appropriate for the level of access you want to enable:
localnode.access = localnode.ACCESS_FULL
localnode.access = localnode.ACCESS_EXCLUSIVE
localnode.access = localnode.ACCESS_PROTECTED
localnode.access = localnode.ACCESS_LOCKOUT
Changing the password
If the instrument is set to the access mode of Protected or Lockout, you must enter a password to
change to a new control interface. You can set the password, as described below.
The default password is admin.
To change the password from the front panel:
1. Press the MENU key.
2. Under System, select Settings.
3. Select the button next to Password. A keypad opens.
4. Enter the new password.
5. Select the OK button on the displayed keyboard. A verification screen is displayed.
6. Enter the new password.
7. Select the OK button on the displayed keyboard. The password is reset.

Keithley DMM7510 Specifications

General

Brand	Keithley
Model	DMM7510
Category	Multimeter
Language	English