Keithley DMM7510 Reference Manual

Section
6: SCPI command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter Referen
ce Manual
6-86 DMM7510-901-01 Rev. B / May 2015
Example 1
CURR:NPLC 0.5
Sets the measurement time for current
measurements to 0.0083 s (0.5/60).
Example 2
RES:NPLC 0.5
Sets the measurement time for resistance
measurements to 0.0083 s (0.5/60).
Example 3
VOLT:NPLC 0.5
Sets the measurement time for voltage
measurements to 0.0083 s (0.5/60).
Also see
[:SENSe[1]]:<function>:APERture (on page 6-53)
Using aperture or NPLCs to adjust speed and accuracy (on page 4-1)
[:SENSe[1]]:<function>:OCOMpensated
This command enables or disables offset compensation.
Type Affected by Where saved Default value
Command and query
Recall settings
Instrument reset
Power cycle
Measure configuration list
Save settings
Measure configuration list
Temperature, 3- or 4-wire RTD:
ON (1)
4-wire resistance: OFF (0)
Usage
[:SENSe[1]]:<function>:OCOMpensated <state>
[:SENSe[1]]:<function>:OCOMpensated?
<function>
The function to which the setting applies; see Functions
<state>
Disable offset compensation: OFF or 0
Enable offset compensation: ON or 1 (for 4-wire resistance, not available
for ranges more than 1 M
Ω
)

Keithley DMM7510 Specifications

General

Resolution	7.5 digits
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	10 µA to 10 A
Resistance Range	10 Ω to 1 GΩ
Sampling Rate	1 MS/s
Memory	27.5 million readings
Display	5 inch capacitive touchscreen
AC Voltage Accuracy	±0.06% of reading
AC Current Range	10 A
Connectivity	USB, LAN, GPIB