Keithley DMM7510 Reference Manual

Model DMM7510
7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:
SCPI command reference
DMM7510-901-01 Rev. B / May 2015 6-215
:TRIGger:LAN<n>:OUT:CONNect:STATe
This command prepares the event generator for outgoing trigger events.
Type Affected by Where saved Default value
Command and query Not applicable Not applicable Not applicable
Usage
:TRIGger:LAN<n>:OUT:CONNect:STATe <state>
:TRIGger:LAN<n>:OUT:CONNect:STATe?
<n>
The LAN event number (1 to 8)
<state>
Do not send event messages: OFF or 0
Prepare to send event messages:
ON
or
1
Details
When this is set to ON, the instrument prepares the event generator to send event messages. For
TCP connections, this opens the TCP connection.
The event generator automatically disconnects when either the protocol or IP address for this event is
changed.
When this is set to OFF, for TCP connections, this closes the TCP connection.
Example
:TRIGger:LAN1:OUT:PROTocol MULT
:TRIGger:LAN1:OUT:CONNect:STATe ON
Set the protocol to multicast and prepare the
event generator to send event messages.
Also see
:TRIGger:LAN<n>:OUT:IP:ADDRess (on page 6-215)
:TRIGger:LAN<n>:OUT:PROTocol (on page 6-217)
:TRIGger:LAN<n>:OUT:IP:ADDRess
This command specifies the address (in dotted-decimal format) of UDP or TCP listeners.
Type Affected by Where saved Default value
Command and query
Recall settings
Instrument reset
Power cycle
Save settings "0.0.0.0"
Usage
:TRIGger:LAN<n>:OUT:IP:ADDRess "<address>"
:TRIGger:LAN<n>:OUT:IP:ADDRess?
<n>
The LAN event number (1 to 8)
<address>
A string that represents the LAN address in dotted decimal notation

Keithley DMM7510 Specifications

General

Brand	Keithley
Model	DMM7510
Category	Multimeter
Language	English