Keithley DMM7510

In this section:
I see a command that is not in the manual. What is it? ............ 9-1
How do I display the instrument's serial number? .................... 9-2
What VISA resource name is required? ................................... 9-2
Can I use Agilent GPIB cards with Keithley drivers? ................ 9-2
How do I check the USB driver for the device? ........................ 9-2
Which Microsoft Windows operating systems are supported? . 9-4
What to do if the GPIB controller is not recognized? ................ 9-5
I'm receiving GPIB timeout errors. What should I do? .............. 9-5
How do I upgrade the firmware? .............................................. 9-6
Where can I find updated drivers? ........................................... 9-6
How do I change the command set? ........................................ 9-7
Why can't the Model DMM7510 read my USB flash drive? ...... 9-7
How do I save the present state of the instrument? ................. 9-8
Why did my settings change? .................................................. 9-8
What is offset compensation? .................................................. 9-8
What is a configuration list? ..................................................... 9-9
Why do I keep seeing the "Undefined header" error? .............. 9-9
Why do I see the "Query interrupted" error? ............................ 9-9
Why do I see the "Query unterminated" error? ....................... 9-10
I see a command that is not in the manual. What is it?
You may see commands that are internal to the instrument if you:
• Have the event log set to record commands
• Capture commands with the create setup feature
• Capture commands with the record macro feature
• Store settings in a configuration list
If a command is not described in the Command Reference section, do not use it.
The commands that you might see include:
• dmm.measure.configlist.set()
• dmm.performance
Section 9
Frequently asked questions (FAQs)