To Next Page

To Previous Page

Model DMM7510

7½ Digit Graphical Sampling Multimeter Reference Manual Section 8:

TSP command reference

DMM7510-901-01 Rev. B / May 2015 8-265

Details

Setting the pulse width to zero (0) seconds asserts the trigger indefinitely. To release the trigger line,

use trigger.digout[N].release().

Example

digio.line[4].mode = digio.MODE_TRIGGER_OUT

trigger.digout[4].pulsewidth = 20e-6

Sets the pulse width for trigger line 4 to

Also see

digio.line[N].mode (on page 8-52)

digio.line[N].reset() (on page 8-54)

Digital I/O port configuration (on page 3-49)

trigger.digout[N].assert() (on page 8-263)

trigger.digout[N].release() (on page 8-265)

trigger.digout[N].release()

This function releases an indefinite length or latched trigger.

Type TSP-Link accessible

Affected by Where saved Default value

Function

Yes

Usage

trigger.digout[N].release()

Digital I/O trigger line (1 to 6)

Details

Releases a trigger that was asserted with an indefinite pulsewidth time. It also releases a trigger that

was latched in response to receiving a synchronous mode trigger. Only the specified trigger line is

affected.

Example

digio.line[4].mode = digio.MODE_TRIGGER_OUT

trigger.digout[4].release()

Releases digital I/O trigger line 4.

Also see

digio.line[N].mode (on page 8-52)

Digital I/O port configuration (on page 3-49)

trigger.digout[N].assert() (on page 8-263)

trigger.digout[N].pulsewidth (on page 8-264)

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510