8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
8-110 DMM7510-901-01 Rev. B / May 2015
dmm.digitize.readwithtime()
This function initiates digitize measurements and returns the last actual measurement and time information in
UTC format without using the trigger mode.
Type TSP-Link accessible
Affected by Where saved Default value
Usage
reading, seconds, fractional = dmm.digitize.readwithtime()
dmm.digitize.readwithtime(bufferName)
The last reading of the measurement process
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2) or a user-defined buffer; if no buffer is specified, this parameter
defaults to
Functions
dmm.FUNC_DIGITIZE_CURRENT
dmm.FUNC_DIGITIZE_VOLTAGE
Details
This command initiates digitize measurements using the present function setting, stores the readings
in a reading buffer, and returns the last reading.
The dmm.digitize.count attribute determines how many measurements are performed.
When you use a reading buffer with a command or action that makes multiple readings, all readings
are available in the reading buffer. However, only the last reading is returned as a reading with the
command.
If you define a specific reading buffer, the reading buffer must exist before you make the
measurement.
Example
print(dmm.digitize.readwithtime())
Print the last digitize measurement and time information in
UTC format, which will look similar to:
-0.0003882925875 1415795836 0.946164546
Also see
dmm.digitize.count (on page 8-84)
dmm.measure.readwithtime() (on page 8-178)
trigger.model.load() — SimpleLoop (on page 8-299)
To Next Page
Loading...
Need help?
General
