0: Maintenance Model DMM7510 7½ Digit Graphical Sampling Multimeter
4 DMM7510-901-01 Rev. B / May 2015
Upgrading the firmware
To upgrade the Model DMM7510 firmware, you load an upgrade file into the instrument. You can load
the file from the front-panel USB port using either a remote interface or the front panel of the
instrument. If you are using Test Script Builder (TSB), you can upgrade the firmware from TSB using
a file saved to the computer on which TSB is running.
During the upgrade to new process, the instrument verifies that the version you are loading is newer
than what is on the instrument. If the version is older or at the same revision level, no changes are
made.
If you want to return to a previous version or reload the present version of the firmware, select
Downgrade to Older. This forces the instrument to load the firmware regardless of the version.
The upgrade process normally takes about five minutes.
Upgrade files are available on the Keithley Instruments website
(http://www.keithley.com).
To find firmware files on the Keithley Instruments website:
1. Select the Support tab.
2. In the model number box, type DMM7510.
3. Select Firmware.
4. Click the search button. A list of available firmware updates and any available documentation for
the instrument is displayed.
5. Click the file you want to download.
Disconnect the input terminals before you upgrade or downgrade.
Do not remove power from the Model DMM7510 or remove the USB flash drive while an upgrade or
downgrade is in progress. Wait until the instrument completes the procedure and shows the opening
display. If you are upgrading a Model DMM7510-NFP instrument, the LAN and 1588 LEDs on the
front panel blink during the upgrade and stop when the upgrade is complete.
To Next Page
Loading...
Need help?
General
