2: General operation Model DMM7510 7½ Digit Graphical Sampling Multimeter
2-2 DMM7510-901-01 Rev. B / May 2015
The power cord supplied with the Model DMM7510 contains a separate protective earth
(safety ground) wire for use with grounded outlets. When proper connections are made, the
instrument chassis is connected to power-line ground through the ground wire in the power
cord. In the event of a failure, not using a properly grounded protective earth and grounded
outlet may result in personal injury or death due to electric shock.
Do not replace detachable mains supply cords with inadequately rated cords. Failure to use
properly rated cords may result in personal injury or death due to electric shock.
Connect the power cord
To connect the power cord:
1. Make sure that the front panel POWER switch is in the off (O) position.
2. Connect the female end of the supplied power cord to the AC receptacle on the rear panel.
3. Connect the other end of the power cord to a grounded AC outlet.
Turn the Model DMM7510 on or off
To turn a Model DMM7510 on:
1. Disconnect any devices under test (DUTs) from the Model DMM7510.
2. Press the front-panel POWER switch to place it in the on (|) position.
The instrument displays a status bar as the instrument powers on. The Home screen is displayed
when power on is complete.
To turn a Model DMM7510 off:
1. Press the front-panel POWER switch to place it in the off (O) position.
To Next Page
Loading...
Need help?
General
