Keithley DMM7510 Reference Manual

Section
8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
8-246 DMM7510-901-01 Rev. B / May 2015
status.questionable.condition
This attribute reads the Questionable Condition Register of the status model.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R) Yes Not applicable Not applicable Not applicable
Usage
questionableRegister = status.questionable.condition
questionableRegister
The value of the register (0 to 65535)
Details
This command reads the contents of the Questionable Condition Register, which is one of the
Questionable Event Registers.
For detail on interpreting the value of a register, see Understanding bit settings (on page 14
).
Example
print(status.questionable.condition)
Reads the Questionable Condition Register.
Also see
Questionable Event Register (on page 7)
Understanding bit settings (on page 14)
status.questionable.enable
This attribute sets or reads the contents of the questionable event enable register of the status model.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes status.preset() Nonvolatile memory 0
Usage
questionableRegister = status.questionable.enable
status.questionable.enable = questionableRegister
questionableRegister
The value of the register (0 to 65535)
Details
This command sets or reads the contents of the Enable register of the Questionable Event Register.
When one of these bits is set, when the corresponding bit in the Questionable Event Register or
Questionable Condition Register is set, the MSB and QSM bits in the Status Byte Register are set.
For detail on interpreting the value of a register, see Understanding bit settings (on page 14
).
Example
status.questionable.enable = 17
print(status.questionable.enable)
Set bits 0 and 4 of the Questionable Event
Enable Register.
Returns 17, which indicates the register was
set correctly.
Also see
Questionable Event Register (on page 7)

Keithley DMM7510 Specifications

General

Resolution	7.5 digits
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	10 µA to 10 A
Resistance Range	10 Ω to 1 GΩ
Sampling Rate	1 MS/s
Memory	27.5 million readings
Display	5 inch capacitive touchscreen
AC Voltage Accuracy	±0.06% of reading
AC Current Range	10 A
Connectivity	USB, LAN, GPIB