To Next Page

To Previous Page

Model DMM7510

7½ Digit Graphical Sampling Multimeter Reference Manual Section 6:

SCPI command reference

DMM7510-901-01 Rev. B / May 2015 6-239

:TRIGger:TIMer<n>:STARt:OVERrun?

This command indicates if an event was ignored because of the event detector state.

Type Affected by Where saved Default value

Query only

Not applicable

Usage

:TRIGger:TIMer<n>:STARt:OVERrun?

<n>

Trigger timer number (1 to 4)

Details

This command indicates if an event was ignored because the event detector was already in the

detected state when the event occurred.

This is an indication of the state of the event detector built into the timer itself. It does not indicate if

an overrun occurred in any other part of the trigger model or in any other construct that is monitoring

the delay completion event. It also is not an indication of a delay overrun.

This returns 0 if there is no overrun or 1 if there is an overrun.

Example

TRIG:TIM1:STAR:OVER?

Checks the overrun status on trigger timer 1.

Also see

None

Keithley DMM7510 Reference Manual

Other manuals for Keithley DMM7510