7½ Digit Graphical Sampling Multimeter Reference Manual Section 8:
DMM7510-901-01 Rev. B / May 2015 8-161
dmm.measure.limit[Y].enable
This attribute enables or disables a limit test on the measurement from the selected measure function.
Type TSP-Link accessible Affected by Where saved Default value
Instrument reset
Power cycle
Measure configuration list
Measure configuration list
Usage
state = dmm.measure.limit[Y].enable
dmm.measure.limit[Y].enable = state
Limit Y testing:
• Disable: dmm.OFF
•
Functions
dmm.FUNC_DIGITIZE_CURRENT
dmm.FUNC_DIGITIZE_VOLTAGE
Details
This command enables or disables a limit test for the selected measurement function. When this
attribute is enabled, the limit Y testing occurs on each measurement made by the instrument. Limit Y
testing compares the measurements to the high and low limit values. If a measurement falls outside
these limits, the test fails.
Example
See dmm.measure.limit[Y].low.value (on page 8-164) for an example of how to use this command.
Also see
dmm.digitize.limit[Y].enable (on page 8-95)
dmm.measure.limit[Y].autoclear (on page 8-159)
dmm.measure.limit[Y].clear() (on page 8-160)
dmm.measure.limit[Y].fail (on page 8-162)
dmm.measure.limit[Y].high.value (on page 8-163)
dmm.measure.limit[Y].low.value (on page 8-164)
To Next Page
Loading...
Need help?
General
