Keithley DMM7510

Model DMM7510
7½ Digit Graphical Sampling Multimeter Reference Manual Section 8:
TSP command reference
DMM7510-901-01 Rev. B / May 2015 8-349
tsplink.line[N].reset()
This function resets some of the TSP-Link trigger attributes to their factory defaults.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
tsplink.line[N].reset()
N
The trigger line (1 to 3)
Details
The tsplink.line[N].reset() function resets the following attributes to their default values:
• trigger.tsplinkin[N].edge
• trigger.tsplinkout[N].logic
• tsplink.line[N].mode
• trigger.tsplinkout[N].stimulus
• trigger.tsplinkout[N].pulsewidth
This also clears trigger.tsplinkin[N].overrun.
Example
tsplink.line[3].reset()
Resets TSP-Link trigger line 3
attributes to default values.
Also see
trigger.tsplinkin[N].edge (on page 8-339)
trigger.tsplinkin[N].overrun (on page 8-340)
trigger.tsplinkout[N].logic (on page 8-342)
trigger.tsplinkout[N].pulsewidth (on page 8-342)
trigger.tsplinkout[N].stimulus (on page 8-344)
tsplink.line[N].mode (on page 8-348)