Keithley DMM7510 Reference Manual

Section
6: SCPI command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
6-98 DMM7510-901-01 Rev. B / May 2015
[:SENSe[1]]:<function>:RTD:BETA
This command contains the beta value of a user-defined RTD.
Type Affected by Where saved Default value
Command and query
Recall settings
Instrument reset
Power cycle
Measure configuration list
Save settings
Measure configuration list
0.10863
Usage
[:SENSe[1]]:<function>:RTD:BETA <value>
[:SENSe[1]]:<function>:RTD:BETA DEFault
[:SENSe[1]]:<function>:RTD:BETA MINimum
[:SENSe[1]]:<function>:RTD:BETA MAXimum
[:SENSe[1]]:<function>:RTD:BETA?
[:SENSe[1]]:<function>:RTD:BETA? DEFault
[:SENSe[1]]:<function>:RTD:BETA? MINimum
[:SENSe[1]]:<function>:RTD:BETA? MAXimum
<function>
The function to which the setting applies; see Functions
<value>
0 to 1
Functions
VOLTage[:DC]
RESistance
TEMPerature
VOLTage[:DC]:RATio
VOLTage:AC
FRESistance
CONTinuity
DIGitize:VOLTage
CURRent[:DC]
DIODe
FREQuency[:VOLTage]
DIGitize:CURRent
CURRent:AC
CAPacitance
PERiod[:VOLTage]
Details
This attribute is only valid when:
• The function is set to temperature.
• The transducer type is set to 3 or 4-wire RTD.
• The RTD type is set to user-defined.
Example
:FUNC "TEMP"
:TEMP:TRANsducer TRTD
:TEMP:RTD:THR USER
:TEMP:RTD:ALPH .005
:TEMP:RTD:DELT .00385
:TEMP:RTD:ZERO 120
:TEMP:RTD:BETA .3
Set the measure function to temperature.
Set the transducer type to 3-wire RTD.
Set the RTD type to User.
Set the alpha RTD value to 0.005.
Set the delta RTD value to 0.00385.
Set the zero RTD value to 120.
Set the beta RTD value to 0.3.
Also see
[:SENSe[1]]:<function>:RTD:FOUR (on page 6-100)
[:SENSe[1]]:<function>:RTD:THRee (on page 6-101)
[:SENSe[1]]:<function>:TRANsducer (on page 6-112)

Keithley DMM7510 Specifications

General

Brand	Keithley
Model	DMM7510
Category	Multimeter
Language	English