Keithley DMM7510 Reference Manual

Section
2: General operation Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
2-10 DMM7510-901-01 Rev. B / May 2015
Adjust the backlight brightness and dimmer
You can adjust the brightness of the Model DMM7510 touchscreen display and buttons from the front
panel or over a remote interface. You can also set the backlight to dim after a specified period has
passed with no front-panel activity (available from the front-panel display only). The backlight settings
set through the front-panel display are saved through a reset or power cycle.
Screen life is affected by how long the screen is on at full brightness. The higher the brightness
setting and the longer the screen is bright, the shorter the screen life.
To adjust the backlight brightness from the front panel:
1. Press the MENU key.
2. Under System, select Settings.
3. Select the button next to Backlight Brightness. The Backlight Brightness dialog box opens.
4. Drag the sliding adjustment to set the backlight.
5. Select OK to save your setting.
To set the backlight dimmer from the front panel:
1. Press the MENU key.
2. Under System, select Settings.
3. Select the button next to Backlight Dimmer. The Backlight Dimmer dialog box opens.
4. Select a dimmer setting.
To adjust the brightness using the SCPI remote interface:
Send the following command:
:DISPlay:LIGHt:STATe <brightness>
Where <brightness> is one of the following options:
• Full brightness: ON100
• 75 % brightness: ON75
• 50 % brightness: ON50
• 25 % brightness: ON25
• Display off: OFF
• Display, key lights, and all indicators off: BLACkout

Keithley DMM7510 Specifications

General

Resolution	7.5 digits
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	10 µA to 10 A
Resistance Range	10 Ω to 1 GΩ
Sampling Rate	1 MS/s
Memory	27.5 million readings
Display	5 inch capacitive touchscreen
AC Voltage Accuracy	±0.06% of reading
AC Current Range	10 A
Connectivity	USB, LAN, GPIB