Keithley DMM7510 Reference Manual

Section
8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
8-192 DMM7510-901-01 Rev. B / May 2015
dmm.measure.thermocouple
This attribute indicates the thermocouple type.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes
Restore configuration
Instrument reset
Power cycle
Measure configuration list
Configuration script
Measure configuration list
dmm.THERMOCOUPLE_K
Usage
value = dmm.measure.thermocouple
dmm.measure.thermocouple = value
value
The thermocouple type:
• dmm.THERMOCOUPLE_B
• dmm.THERMOCOUPLE_E
• dmm.THERMOCOUPLE_J
• dmm.THERMOCOUPLE_K
• dmm.THERMOCOUPLE_N
• dmm.THERMOCOUPLE_R
• dmm.THERMOCOUPLE_S
•
dmm.THERMOCOUPLE_T
Functions
dmm.FUNC_DC_VOLTAGE
dmm.FUNC_RESISTANCE
dmm.FUNC_ACV_FREQUENCY
dmm.FUNC_AC_VOLTAGE
dmm.FUNC_4W_RESISTANCE
dmm.FUNC_ACV_PERIOD
dmm.FUNC_DC_CURRENT
dmm.FUNC_DIODE
dmm.FUNC_DCV_RATIO
dmm.FUNC_AC_CURRENT
dmm.FUNC_CAPACITANCE
dmm.FUNC_DIGITIZE_CURRENT
dmm.FUNC_TEMPERATURE
dmm.FUNC_CONTINUITY
dmm.FUNC_DIGITIZE_VOLTAGE
Details
This command is only applicable when the transducer type is set to thermocouple.
Example
dmm.measure.func = dmm.FUNC_TEMPERATURE
dmm.measure.transducer = dmm.TRANS_THERMOCOUPLE
dmm.measure.thermocouple = dmm.THERMOCOUPLE_J
Set the measure function to temperature.
Set the transducer type to thermocouple.
Set the thermocouple type to J.
Also see
dmm.measure.transducer (on page 8-197)
dmm.measure.simreftemperature (on page 8-190)
Temperature measurements (on page 2-120)

Keithley DMM7510 Specifications

General

Brand	Keithley
Model	DMM7510
Category	Multimeter
Language	English