EasyManua.ls Logo

Keithley DMM7510

Keithley DMM7510
1036 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section
8: TSP command reference Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
8-66 DMM7510-901-01 Rev. B / May 2015
display.lightstate
This attribute sets the light output level of the front-panel display.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Power cycle Not applicable display.STATE_LCD_50
Usage
brightness = display.lightstate
display.lightstate = brightness
brightness
The brightness of the display:
Full brightness: display.STATE_LCD_100
75 % brightness: display.STATE_LCD_75
50 % brightness: display.STATE_LCD_50
25 % brightness: display.STATE_LCD_25
Display off: display.STATE_LCD_OFF
Display, key lights, and all indicators off:
display.STATE_BLACKOUT
Details
This command changes the light output of the front panel when a test requires different instrument
illumination levels.
The change in illumination is temporary. The normal backlight settings are restored after a power
cycle. You can use this to reset a display that is already dimmed by the front-panel Backlight Dimmer.
Screen life is affected by how long the screen is on at full brightness. The higher the brightness
setting and the longer the screen is bright, the shorter the screen life.
Example
display.lightstate = display.STATE_LCD_50
Set the display brightness to 50 %.
Also see
Adjust the backlight brightness and dimmer (on page 2-10)

Table of Contents

Other manuals for Keithley DMM7510

Related product manuals